Different EV Charger Connectors for Electric Car

Different EV Charger Connectors for Electric Car

Fast Chargers

Fast chargers are typically rated at either 7 kW or 22 kW (single- or three-phase 32A). The vast majority of fast chargers provide AC charging, though some networks are installing 25 kW DC chargers with CCS or CHAdeMO connectors.

Charging times vary on unit speed and the vehicle, but a 7 kW charger will recharge a compatible EV with a 40 kWh battery in 4-6 hours, and a 22 kW charger in 1-2 hours. Fast chargers tend to be found at destinations such as car parks, supermarkets, or leisure centres, where you are likely be parked at for an hour or more.

The majority of fast chargers are 7 kW and untethered, though some home and workplace based units have cables attached.

Should a cable be tethered to the device, only models compatible with that connector type will be able to use it; e.g. a Type 1 tethered cable could be used by a first-generation Nissan Leaf, but not a second-generation Leaf, which has a Type 2 inlet. Untethered units are therefore more flexible and can be used by any EV with the correct cable.

Charging rates when using a fast charger will depend on the car’s on-board charger, with not all models able to accept 7 kW or more.

These models can still be plugged in to the charge point, but will only draw the maximum power accepted by the on-board charger. For example, a Nissan Leaf with a 3.3 kW on-board charger will only draw a maximum of 3.3 kW, even if the fast charge point is 7 kW or 22 kW.

Tesla’s ‘destination’ chargers provide 11 kW or 22 kW of power but, like the Supercharger network, are intended only or use by Tesla models. Tesla does provide some standard Type 2 chargers at many of its destination locations, and these are compatible with any plug-in model using the compatible connector.

Almost all EVs and PHEVs are able to charge on a Type 2 units, with the correct cable at least. It is by far the most common public charge point standard around, and most plug-in car owners will have a cable with a Type 2 connector charger-side.

 

Slow chargers

Most slow charging units are rated at up to 3 kW, a rounded figure that captures most slow-charging devices. In reality, slow charging is carried out between 2.3 kW and 6 kW, though the most common slow chargers are rated at 3.6 kW (16A). Charging on a three-pin plug will typically see the car draw 2.3 kW (10A), while the majority of lamp-post chargers are rated at 5.5 kW because of existing infrastructure – some are 3 kW however.

Charging times vary depending on the charging unit and EV being charged, but a full charge on a 3 kW unit will typically take 6-12 hours. Most slow charging units are untethered, meaning that a cable is required to connect the EV with the charge point.

Slow charging is a very common method of charging electric vehicles, used by many owners to charge at home overnight. However, slow units aren’t necessarily restricted to home use, with workplace and public points also able to be found. Because of the longer charging times over fast units, slow public charge points are less common and tend to be older devices.

While slow charging can be carried out via a three-pin socket using a standard 3-pin socket, because of the higher current demands of EVs and the longer amount of time spent charging, it is strongly recommended that those who need to charge regularly at home or the workplace get a dedicated EV charging unit installed by an accredited installer.

All plug-in EVs can charge using at least one of the above slow connectors using the appropriate cable. Most home units have the same Type 2 inlet as found on public chargers, or tethered with a Type 1 connector where this is suitable for a particular EV.